Alinco DJ-V57 - Manual (Page 54)

9.Cloning and Packet Operation
9
54
9.1.3 Master Unit Operation
1. In the Clone mode, press the PTT key of the
master unit. "SD***" is displayed on the LCD,
and starts the data-transfer.
2. After the transfer is completed successfully,
"PASS" is displayed.
3. Turn off the unit. Repeat the same sequence to
clone more units.
Stop moving the SD***, COMERR etc. on the display means that the cloning is
failed. Please read below and repeat the procedure.
9.1.4 Slave Unit Operation
1. When the data is sent from the master unit,
"LD***" is displayed on the receiving unit, and the
data-transfer starts.
2. After the transfer is completed, "PASS" is
displayed.
3. After the cloning is done, turn off the unit by
pressing the key and remove the cable.
Repeat the same sequence to clone more units.
In case the transfer fails, please turn off the slave unit and perform the reset sequence
(page 57) to turn on again before retry. If you quit cloning of this slave unit, please reset
it anyway otherwise it may not work properly.
Caution
• Don't disconnect the cable during data transmission. If you disconnect the
cable at this time, "COMERR" is displayed on the LCD of the master unit,
and transmission is aborted.
• When data transfer is performed using the Clone function, all settings in the
slave unit are overwritten by the master unit settings.
There is NO data back-up available in unit's memory.