Alinco DR-635 - Manual (Page 38)

36
Useful functions
Single-band mode
This is to use the unit as a single-band transceiver only for VHF or UHF, by eliminating the display
on the SUB side.
1.
Press the BAND key while pressing and hold-
ing the FUNC key.
The display on the SUB side disappears and its
function is temporarily suspended.
While in the V-V/U-U mode, the unit will not
enter in to the single-band mode.
VFO Auto-program setting function
This is to program various automatic settings in a certain frequency range in the VFO mode.
It is useful for quick repeater access.
1.
Program the lower edge frequency of the de-
sired range as well as other parameters such as
repeater shift, CTCSS tone into the [AL] chan-
nel in the memory mode (Refer page 19).
Programmable items are frequency, shift direc-
tion, offset frequency, tone ENC frequency and
its setting, tone DEC frequency and its setting,
DCSEN code and its setting, and DESDEC set-
ting.
2.
As above, program the higher edge frequency
in the [AH] channel of the memory. Disregard
other settings such as CTCSS tones or repeater
shift.
3.
In the VFO mode, what has been programmed
in the AL memory is automatically set within
the frequency band between AL and AH.
Temporary setting change is possible between
AL and AH, but once the frequency is changed
by rotating the dial, all the preset values in AL
will be restored.
4.
To disable this function, delete the AL memory
channel data reffering P21.
When 439.000MHz 88.5Hz ENC-5.000MHZ
shift is set in AL
Shows an example within
VFO auto-program setting