Alinco DJ-100 - Manual (Page 70)

Professional
FM Transceiver
53
AUXILIARY FUNCTIONS
Cable Cloning
Communication Note
With this function, you can copy the programming data of the transceiver to another one; it can copy
parameters and memory programming data to another transceiver.
Connection: use wire cloning cable (optional accessory) to connect main transceiver with sub-
transceiver through reading/ writing programmable interface.
Setup: main transceiver party
1.Hold [PF1] side key to power on, LCD displays "CLONE", main transceiver enters into copy mode.
2.Press [PTT] key , LCD displays "CLONE XX", XX means the transmitted data quantity.
3.After data copies completely, LCD displays "CLONE OK".
4.Main transceiver stays in this mode preparing to next copy, restart main transceiver to exit copy mode.
Setup: sub-transceiver party.
1.When receiving data, LCD displays "CLONE XX ", XX means the received data quantity.
2.After data received sub-transceiver returns to normal mode.
3.Power off, take over cable line and link to another sub-transceiver which you want to copy.
If data can not transfer successfully, power off main transceiver and sub-transceiver, check the cable
line and repeat the process.
This function is used to receive ANI call matching the communication note, and displays the correspon-
ding name of the code in LCD. It is similar to mobile phone communication note. You can set 15 groups
of 5TONE note and DTMF note each. You only need to set the opposing party ID with the corresponding
name. For more information, please refer to the communication note option in software.
For dealers only. Please contact the authorized importer of your area for more details.