Eiki Network Board MD13NET - Manual (Page 10)

10
Installation
The following are instructions for attaching this product to the projector and connect-
ing it to the network. Please review the entire procedure to become familiar with it.
Check package
(p.11)
1
Installation
(p.12-14)
2
Network configuration
(p.15-24)
3
Setting up is completed.
Please check the contents of a package. This product contains a network
board, an owner’s manual (this manual), a ferrite core and 2 screws. Also
please check the name and function of each part.
1. Mount this product to the projector.
2. Connect the LAN cable and join it to the network.
3. Confirm that the network menus are activated on the setting menu of the
projector.
Configure the network of the projector. Separate configurations must be set
up for each network to which the projector will be connected.
☛ Configure the network with the projector.
☛ Configure the network with the computer.
Flow of installation
The preparation is completed to control the projector connected to the network. At
next step, set up and control the projector via the network by using the web browser
installed on your computer. Please see chapter “2: Basic setting and operation” on
page 25.