Eiki Network Board MD13NET - Manual (Page 14)

14
Installation
[3] Confirmation of network menu activity
When installing this product to the projector, the network on-screen menu items for
this product are activated automatically.
If not activated, the product may not have
been installed correctly . Please check chapter “Mounting” on page 12.
Turn on the projector and display the menu on the screen.
Confirmation of network setting menu [Network]
Using the pointers on the remote
control handset or on the projector,
select the
Network icon from the
Setting sub menu, and then press
the SELECT button once. Check if
the setting is On . If not, switch to
On by using the pointer / . The
power indicator on this product will
illuminate red.
Press the
SELECT button again,
the network setting menu appears
on the screen as follows. For fur-
ther information about network set-
ting, please see chapter “Network
configuration”on the next page.
Confirmation of password setting menu [Display]
Using the pointers on the remote
control handset or on the projector,
select the
Display icon from the
Setting sub menu, and then press
the SELECT button twice. The
password setting menu appears on
the screen. If not, please check if
the function of Network is
On as
explained on previous item
“Confirmation of network setting
menu”. For further information
about password setting, please see
“Password setting menu” on page
17.
▲
▲
Password 0 0 0 0
SET CANCEL
NETWORK SETTING
IP Address
Sub net
Gateway
DNS
192 168 0 2
255 255 255 0
0 0 0 0
0 0 0 0
SET CANCEL
* The above on-screen display may differ from
the actual display depending on the functions
of the projector you use.