Eiki Network Board MD13NET - Manual (Page 21)

21
Network Board
OWNER’S MANUAL
Configure the network of computer
ENGLISH
Windows 2000/NT4.0
This example explains how to set the following network address.
1
Select the Network and Dial-up Connections
menu from [Start] - [Settings] menu.
2
Click the Local Area Connection icon with
right button of the mouse and then select the
Properties menu from the popup menu. The
right window will appear on the screen.
3
Select the Internet Protocol(TCP/IP) *1 on the
General tab of the “Local Area Connection
Properties” dialog window and then press the
Properties button.
4
On the “Internet Protocol (TCP/IP) Properties”
dialog window, select the
Use the following
IP address button and then enter the IP
Address* 2 and Subnet mask.
5
Enter the Default gateway address.
✐ This setting is not needed if the network does
not provide the gateway (router).
6
Click the OK button, the setting window will
be closed.
✐ To change the configuration, you may need administrator privileges.
IP Address : 192.168.0.5
Subnet Mask : 255.255.255.0
Gateway Address : 192.168.100.1
*1 Select the “TCP/IP” item of the LAN card you use. If the “TCP/IP” item is not listed in the
column, you need to install the TCP/IP protocol. For further information refer to the user's
manual of your computer.
*2 If the network already has the TCP/IP protocol set, enter with the same IP network number
for the IP address and Subnet mask.
*3 There are some ways to set up the network depending on your computer’s environment.