Eiki Network Board MD13NET - Manual (Page 18)

18
Installation
Configure the network with the computer
This example explains how to set the following configuration.
The default network configuration is set as follows.
Make sure that the projector is connected to the network and then turn the projector
on.
1
Temporarily* 1 set up your computer network configuration to the same IP network
number as the Network Board. For example, change your computer network con-
figuration as follows and restart the computer.
The network configuration of computer differs depending on each network environ-
ment or your computer. For further information, please see the next chapter
“Configure the network of computer”.
IP Address : 192.168.0.2
Subnet Mask : 255.255.255.0
Default Gateway : (blank)
DNS : (blank)
IP Address : 192.168.0.2
Subnet Mask : 255.255.255.0
Default Gateway : 0.0.0.0
DNS : 0.0.0.0
IP Address : 192.168.1.201
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.1.1
DNS
: 0.0.0.0
B
*1 Change your computer’s network configuration temporarily. After completing the set up for
the projector, you must set up again to the original network configuration for your computer.
It is recommended to make a note of those network settings.