Archgard 27-DVIE22N - Manual (Page 16)

27-DVIE22
16
TOP VIEW
Fresh Air Exhaust
FRONT VIEW
Surround
On/Off
Rocker
Switch
APPLIANCE DESCRIPTION
Before placing the appliance into the fireplace, check the hearth of the fireplace to see if it is level
with the front of the fireplace. If it is not, measure the depth of the hearth. Loosen the three screws of
the leveling “L” bracket at the back of the appliance. Lower it to the measurement obtained and
tighten the screws.
ELECTRICAL CONNECTIONS
The 27-DVIE22 comes complete with an adjustable speed fan with 6 levels wired directly to the main
control module for your protection against shock hazard.
Do not cut or remove the grounding prong from this plug.
NOTE: This appliance, when installed, must be electrically grounded in accordance with local codes
or, in the absence of local codes, with the National Electrical Code, ANSI / NFPA 70, or the
Canadian Electrical code, CSA C22.1.
LEVELING THE 27-DVIE22
Rear Level
Front Level
Located slightly in from the front edge of the fireplace is the new level-
ing feature. Leveling bolts can be installed to enable you to raise the
front of the firebox if necessary. If you need higher adjustment you only
need to change to a longer bolt. If no rise is required simply leave
empty.
Fig. 16-C Fig. 16-D
N O T E
Main On/Off switch must be connected to the surround switch or jumpered and in the “on” position for
the remote to operate the fireplace
Ceramic
Glass with
standard
black door
frame
Shown with 27-SKSBS Trim
Fig. 16-A
Fig. 16-B