Archgard 27-DVIE22N - Manual (Page 20)

27-DVIE22
20
LOG PLACEMENT
The Archgard pan burner bed and fiber logs are designed to give a realistic fire package, and created
to look the same as the day they were originally installed. Care must be given when first installing the
logs, and if removed for servicing, as they can be damaged or broken if not handled properly.
After opening the log set package, inspect the logs to ensure that no damage has occurred inside the
package. Please report any damage immediately to your Authorized Archgard Dealer.
Gas and vent connection must be made before installing the embers and logs on the pan burner.
Locate the embers and logs and place them on their prospective locations. Refer to the pictured in-
structions on the following pages that will show how to place all six (6) logs. Pins and holes must be
aligned with logs and burner.
Locator Pins
N O T E
Improper placement of logs and embers may cause soot accumulation on the internal parts and glass. This is not covered
under warranty. Do not use broken or damaged logs.
W A R N I N G
Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.
N O T E
Installing the fiber logs in any position other than shown can result in flame impingement causing
soot accumulation on the logs, brick liner and ceramic glass viewing area.
LOCATOR PINS
Fig. 20-A