H3C Technologies H3C S5130 Series Switches - Manual (Page 61)

54
connecting AC power source, 15
connecting console cable, 18
connecting power cord, 14
connecting RPS, 16
EMI prevention, 2
grounding switch through AC power module PE
wire, 11
grounding switch with grounding conductor
buried in the earth ground, 11
grounding switch with grounding strip, 9
grounding the switch, 9
power module installation, 12 , 13
power module removal, 12 , 13
powering on switch, 19
troubleshooting fixed power module failure, 28
troubleshooting hot-swappable power module
failure, 29
troubleshooting power module failure, 28
electromagnetic interference. See EMI prevention
EMI prevention, 2
emulation (parameter), 19
environment
examining installation site, 1
site cleanliness, 2
site dust concentration, 2
site gas saturation, 2
site humidity, 2
site temperature, 2
examining installation site, 1
F
fiber
laser safety recommendations, 3
fixed power module
failure (troubleshooting), 28
flow control (parameter), 19
flowchart of IRF fabric setup, 21
G
garbled terminal display (troubleshooting), 30
gas (installation site), 2
grounding
EMI prevention, 2
grounding conductor buried in the earth
ground, 11
grounding strip, 9
switch, 9
switch through AC power module PE wire, 11
switch with grounding conductor buried in the earth
ground,
11
switch with grounding strip, 9
H
hardware
10/100/1000 Base-T autosensing Ethernet port
LED technical specifications, 47
10/100/1000 Base-T Ethernet port technical
specifications, 42
100/1000Base-X SFP port LED technical
specifications, 50
100/1000Base-X SFP port technical
specifications, 43
combo interface technical specifications, 46
connecting –48 VDC power source, 16
connecting AC power source, 15
connecting RPS, 16
console port technical specifications, 42
grounding switch, 9
grounding switch through AC power module PE
wire, 11
grounding switch with grounding conductor buried
in the earth ground, 11
grounding switch with grounding strip, 9
port mode LED technical specifications, 47
port technical specifications, 42
power module installation, 12 , 13
power module removal, 12 , 13
power module status LED technical
specifications, 46
rack-mounting the switch, 7
RPS status LED technical specifications, 46
SFP+ port LED technical specifications, 50
SFP+ port technical specifications, 45
switch installation, 4
switch installation on 19-inch rack, 4
system status LED, 46
verifying switch 19-inch rack installation, 17
workbench switch mounting, 8
hot-swappable power module
failure (troubleshooting), 29
humidity (installation site), 2
I