H3C Technologies H3C S3100V2 Series Switches User Manual
Page 32
Advertising
26
Step3
Insert the expansion anchors into the holes, and remove the hex nut, spring washer, and flat washer from
each expansion anchor, as shown in
.
Figure 34 Install an expansion anchor
Step4
Supporting the switch with the network ports facing downwards, insert the mounting brackets into the
four expansion anchors.
Step5
Attach the flat washer, spring washer, and hex nut in turn to each expansion anchor, and fasten the hex
nut with a wrench, as shown in
Figure 35 Mount the switch on a wall
(1) Hex nut
(2) Spring washer
(3) Flat washer
CAUTION:
Make sure the front and rear of the chassis are perpendicular to the floor.
Advertising