H3C Technologies H3C MSR 50 - Manual (Page 100)

92
Member IP : 10.1.1.3
The output shows that in VRRP group 1, Router A is the master and Router B and Router C are the
backups. Each router has one AVF and two LVFs that act as the backups.
# When Ethernet 1/2 on Router A fails, use the display vrrp verbose command to display the
detailed information about VRRP group 1 on Router A.
[RouterA-Ethernet1/1] display vrrp verbose
IPv4 Standby Information:
Run Mode : Load Balance
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface Ethernet1/1
VRID : 1 Adver Timer : 1
Admin Status : Up State : Master
Config Pri : 120 Running Pri : 120
Preempt Mode : Yes Delay Time : 5
Auth Type : None
Virtual IP : 10.1.1.1
Member IP List : 10.1.1.2 (Local, Master)
10.1.1.3 (Backup)
10.1.1.4 (Backup)
Forwarder Information: 3 Forwarders 0 Active
Config Weight : 255
Running Weight : 5
Forwarder 01
State : Initialize
Virtual MAC : 000f-e2ff-0011 (Owner)
Owner ID : 0000-5e01-1101
Priority : 0
Active : 10.1.1.4
Forwarder 02
State : Initialize
Virtual MAC : 000f-e2ff-0012 (Learnt)
Owner ID : 0000-5e01-1103
Priority : 0
Active : 10.1.1.3
Forwarder 03
State : Initialize
Virtual MAC : 000f-e2ff-0013 (Learnt)
Owner ID : 0000-5e01-1105
Priority : 0
Active : 10.1.1.4
Forwarder Weight Track Information:
Track Object : 1 State : Negative Weight Reduced : 250
# Use the display vrrp verbose command to display the detailed information about VRRP group 1
on Router C.
[RouterC-Ethernet1/1] display vrrp verbose
IPv4 Standby Information:
Run Mode : Load Balance