H3C Technologies H3C MSR 50 - Manual (Page 102)

94
# When the timeout timer (about 1800 seconds) expires, display the detailed information about
VRRP group 1 on Router C.
[RouterC-Ethernet1/1] display vrrp verbose
IPv4 Standby Information:
Run Mode : Load Balance
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface Ethernet1/1
VRID : 1 Adver Timer : 1
Admin Status : Up State : Backup
Config Pri : 100 Running Pri : 100
Preempt Mode : Yes Delay Time : 5
Become Master : 4200ms left
Auth Type : None
Virtual IP : 10.1.1.1
Member IP List : 10.1.1.4 (Local, Backup)
10.1.1.2 (Master)
10.1.1.3 (Backup)
Forwarder Information: 2 Forwarders 1 Active
Config Weight : 255
Running Weight : 255
Forwarder 02
State : Listening
Virtual MAC : 000f-e2ff-0012 (Learnt)
Owner ID : 0000-5e01-1103
Priority : 127
Active : 10.1.1.3
Forwarder 03
State : Active
Virtual MAC : 000f-e2ff-0013 (Owner)
Owner ID : 0000-5e01-1105
Priority : 255
Active : local
Forwarder Weight Track Information:
Track Object : 1 State : Positive Weight Reduced : 250
Forwarder Switchover Track Information:
Track Object : 2 State : Positive
Member IP : 10.1.1.2
Track Object : 3 State : Positive
Member IP : 10.1.1.3
The output shows that when the timeout timer expires, the VF corresponding to virtual MAC
address 000f-e2ff-0011 is removed, and no longer forwards the packets destined for the MAC
address.
# When Router A fails, use the display vrrp verbose command to display the detailed information
about VRRP group 1 on Router B.
[RouterB-Ethernet1/1] display vrrp verbose
IPv4 Standby Information:
Run Mode : Load Balance