H3C Technologies H3C MSR 50 - Manual (Page 96)

88
[RouterA] track 1 interface ethernet 1/2
# Configure VF tracking to monitor track entry 1 and specify the value by which the weight
decreases, making the weight of Router A decrease by more than 245 (250 in this example) when
track entry 1 turns to negative. In such a case, another router with a higher weight can take over.
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] vrrp vrid 1 weight track 1 reduced 250
2. Configure Router B:
# Configure VRRP to operate in load balancing mode.
<RouterB> system-view
[RouterB] vrrp mode load-balance
# Create VRRP group 1 and configure its virtual IP address as 10.1.1.1.
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] ip address 10.1.1.3 24
[RouterB-Ethernet1/1] vrrp vrid 1 virtual-ip 10.1.1.1
# Set the priority of Router B in VRRP group 1 to 110, which is higher than that of Router C (100),
so that Router B can become the master when Router A fails.
[RouterB-Ethernet1/1] vrrp vrid 1 priority 110
# Set Router B to operate in preemptive mode and set the preemption delay to 5 seconds.
[RouterB-Ethernet1/1] vrrp vrid 1 preempt-mode timer delay 5
[RouterB-Ethernet1/1] quit
# Create track entry 1 to associate with the physical status of Ethernet 1/2 on Router B. When the
track entry becomes negative, it means that the interface fails.
[RouterB] track 1 interface ethernet 1/2
# Configure VF tracking to monitor track entry 1 and specify the value by which the weight
decreases, making the weight of Router B decrease by more than 245 (250 in this example) when
track entry 1 turns to negative. In such a case, another router with a higher weight can take over.
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] vrrp vrid 1 weight track 1 reduced 250
3. Configure Router C:
# Configure VRRP to operate in load balancing mode.
<RouterC> system-view
[RouterC] vrrp mode load-balance
# Create VRRP group 1 and configure its virtual IP address as 10.1.1.1.
[RouterC] interface ethernet 1/1
[RouterC-Ethernet1/1] ip address 10.1.1.4 24
[RouterC-Ethernet1/1] vrrp vrid 1 virtual-ip 10.1.1.1
# Set Router C to operate in preemptive mode and set the preemption delay to 5 seconds.
[RouterC-Ethernet1/1] vrrp vrid 1 preempt-mode timer delay 5
[RouterC-Ethernet1/1] quit
# Create track entry 1 to associate with the physical status of Ethernet 1/2 on Router C. When the
track entry becomes negative, it means that the interface fails.
[RouterC] track 1 interface ethernet 1/2
# Configure VF tracking to monitor track entry 1 and specify the value by which the weight
decreases, making the weight of Router C decrease by more than 245 (250 in this example) when
track entry 1 turns to negative. In such a case, another router with a higher weight can take over.
[RouterC] interface ethernet 1/1