H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 41)

35
CPLD 2 CPLD Version is 002
FPGA1 Logic Version is 108
FPGA2 Logic Version is 108
Basic Bootrom Version is 1.01
Extend Bootrom Version is 1.01
[Slot 0]WX5540ELSW Hardware Version is NA
[Slot 1]WX5540ERPU Hardware Version is Ver.A
• On the switching engine:
<H3C>display version
H3C Comware Platform Software
Comware Software, Version 5.20, Alpha 2607P01
Copyright (c) 2004-2013 Hangzhou H3C Tech. Co., Ltd. All rights reserved.
H3C WX5540E-LSW uptime is 0 week, 0 day, 0 hour, 6 minutes
H3C WX5540E-LSW with 2 Processors
1024M bytes DDR3
16M bytes Nor Flash Memory
Config Register points to Nor Flash
Hardware Version is Ver.A
CPLDA Version is 002, CPLDB Version is 002
BootRom Version is 1.01
[SubSlot 0] 12GE+12SFP+4SFP Plus Hardware Version is Ver.A
Displaying operational statistics for the device
When you perform routine maintenance or the system fails, you might need to display the operational
information of each feature module to locate failures. Typically, you need to run the display commands
individually. However, you can use the display diagnostic-information command in any view to display
or save the operational statistics of multiple feature modules of the device. This command displays the
output of the display clock, display version, display device, and display current-configuration
commands.
• Save the operational statistics for each feature module of the device:
<H3C>display diagnostic-information
Save or display diagnostic information (Y=save, N=display)? [Y/N]:y
Please input the file name(*.diag)[cfa0:/default.diag]:
The file already exists, overwrite it? [Y/N]:y
Diagnostic information is outputting to cfa0:/default.diag.
Please wait...
Save successfully.
Execute the more default.diag command in user view, and then press the Page Up and Page Down
keys to view the contents of the file default.diag.
• Display the operational statistics for each feature module of the device. (Details not shown.)
<H3C>display diagnostic-information
Save or display diagnostic information (Y=save, N=display)? [Y/N]:n
=================================================================
===============running CPU usage information===============
=================================================================