Grass Valley ADC-1101 - Manual (Page 12)

GUIDE TO INSTALLATION AND OPERATION
8 | ADC-1101
3.3 Remote control using iControl
The operation of the ADC-1101 may be controlled using Miranda’s iControl system.
• This manual describes the control panels associated with the ADC-1101 and their use.
• Please consult the iControl User’s Guide for information about setting up and operating iControl.
In iControl Navigator or iControl Websites, double-click on the ADC-1101 icon to open the control panel.
3.3.1 The iControl graphic interface window
The basic window structure for the ADC-1101 is shown in figure 3.1. The window identification line at the top
gives the card type (ADC-1101), and the slot number in which the card is installed in the Densité frame. On
the left is a Status icon for the card (see Section 3.3.12 for a discussion of status monitoring).
Figure 3.1 ADC-1101 iControl graphic interface window
There are four main sections in the window itself, identified in figure 3.1:
1. The top section displays icons on the left. These icons report different statuses such as card
communication status, input signal and reference signal format and statuses.
Move the cursor over an icon to see its current status in the message area below the icons. If there is
an error status, the message will appear automatically. If there are multiple error messages, the display
will cycle through them
1
2
3
4