Grass Valley ADC-1101 - Manual (Page 20)

GUIDE TO INSTALLATION AND OPERATION
16 | ADC-1101
3.3.9 The Options group
The IP Scope option adds Waveform Monitor and
Vectorscope over IP functions to the ADC-1101,
using data generated by a line scope embedded
in the ADC-1101.
• To activate this option, you must obtain a
licence key from Miranda Technologies Inc.
• Type the licence key in the Enter Key box
and then click on Enable Option to enable
the option’s features
Once the Key has been entered, and the IP
Scope is activated, the controls on this panel can
be used to set its operating parameters
• Enable – Click in the checkbox to turn the
IP Scope ON
• Line – Use the slider to select the video line
that will be displayed by the Line Scope
• Refresh Rate – Use the pulldown to select
how often the display will be refreshed..
3.3.10 The ABUS group
When companion audio cards such as the UAP-
1781 and UAP-1783 are used to provide additional
audio channels, the ABUS audio bus links the
installed audio cards and the ADC-1101. This
panel, called ABUS group, is used to instruct the
ADC-1101 about the presence of installed audio
cards and the system configuration.
Multiple Card Config
A1/A2 Presence: Monitors the presence of
companion audio cards installed in the chassis
(see section 2.2 ADC-1101 Installation).
Card System Config: To enable the audio bus, use
the pull-down box and select your system’s
configuration. Selecting Video restricts available
audio signals to audio channels embedded in the
input signal; Video / A1 or Video / A1 / A2 adds the
audio channels incoming from the installed audio
cards that have been detected.
Figure 3.15 Options group
Figure 3.16 ABUS group