Grass Valley ADC-1101 - Manual (Page 7)

GUIDE TO INSTALLATION AND OPERATION
ADC-1101 | 3
2 Installation
2.1 Unpacking
The following items should be included in the ADC-1101 package:
• ADC-1101 CAV-to-SDI Converter
• ADC-1101-SRP rear panel
• User
manual
2.2 Installation in the Densité frame
The ADC-1101 must be mounted in a DENSITÉ frame. The installation includes both the ADC-1101
module, and the rear panel module. It is not necessary to switch off the frame’s power when installing or
removing the card.
When the ADC-1101 is used in conjunction with an audio module such as the UAP-1783, the ABUS flat
cable must be installed between the ABUS connectors located on the front card edges (see section 1.4).
• Note: for a two card installation, use the two end connectors of the flat cable and leave the
middle one unplugged.
Detailed instructions for installing cards and their associated rear panels in the Densité frame are given in
the Densité Frame manual.
2.3 Connection
All video connections are made on the rear panel:
• Connect the CAV inputs to the three BNC connectors marked CAV IN
• Two SDI outputs are available on BNC connectors.
Component analog input formats supported by the ADC-1101:
525 formats 625 formats
GBR without setup GBR
GBR with setup EBU
SMPTE Beta
Beta without setup
Beta with setup
ADC-1101-SRP
CA
V I
N
G/Y
B/B-Y
R/R-Y
SDI OUT
2
1