Grass Valley 3e CameraMan - Manual (Page 17)

CameraMan 3e 3-CCD Camera Overview
CameraMan 3e 3-CCD Camera Installation and Operations Manual 9
The SHOT Director can communicate with the cam-
eras through either the RS-485 or RS-232 port.
CameraMan LED Displays
On the front of the CameraMan 3e 3-CCD Camera,
there are several LEDs. These indicate various
functions that are being performed by the camera.
Below is a description of each.
When the camera is first powered ON, all LEDs will
illuminate. During this time, basic system hardware
checks are being performed. These checks include
communication with the camera interface board
which verifies proper installation of the camera block
on the pan/tilt unit. After the initial system checks
are completed, the LEDs will turn on and off one by
one in a binary pattern. This pattern represents the
progress the camera is making during hardware ini-
tialization. During this initialization, pan/tilt positions
and camera settings are being restored. Once ini-
tialization is complete, the camera LEDs will repre-
sent the following functions:
DC Power Jack Power input for the CameraMan Camera. Plug
only a Grass Valley power supply (supplied) into
this jack. No other types of power supplies should
be used.
Power Used to power on/off the CameraMan Camera.
Power Indicates that the camera has an active power
supply and is powered ON.
Setup The camera is in the camera setup mode.
COM Indicates that the camera is receiving valid
network data on a communication link (the LEDs
on the back of the camera only indicate line
activity, not valid data).