Grass Valley 3e CameraMan - Manual (Page 23)

Connecting the CameraMan 3e 3-CCD Camera
CameraMan 3e 3-CCD Camera Installation and Operations Manual 15
Connecting to the Camera System
Follow the instructions found in this section to begin
connecting the camera to the system.
Tip: After connecting each cable to the camera, let it
hang loosely behind the camera. Then follow the
instructions about restraining the cables on page 19
before attaching the other ends of the cable to other
equipment. This will relieve undue stress on the
cables, allowing the camera to move freely.
Connecting to Video
Outputs on Mini Docking
Station
FIGURE 2.3 Back of Camera with Video Outs
CameraMan supports both composite and S-VIDEO
formats, although you can use only one at a time.
For composite format, connect to the BNC jack on
the Connector Box on the back of the camera,
labeled COMPOSITE VIDEO OUT, using a standard
coaxial cable with a BNC connector (not provided).
Verify that the Video Select switch is set to COM-
POSITE. The switch is located behind the switch
plate on the back right of the camera.
For S-VIDEO format, connect to the S-VIDEO jack
on the back of the camera using a standard S-
VIDEO cable (not provided). Verify that the Video
Select switch is set to S-VIDEO. The switch is
located behind the switch plate on the back right