Grass Valley 3e CameraMan - Manual (Page 28)

Chapter 2
20 CameraMan 3e 3-CCD Camera Installation and Operations Manual
Connecting the Power
Supply
FIGURE 2.7 Back of Camera with Power
Mount the Power Supply with any orientation, or on
top of a table or roll-about unit by using the following
steps.
1. Verify that the POWER switch, on the back of the
camera, is turned OFF.
2. Plug the 5.5mm female connector from the
power supply cord into the DC POWER jack in
the back of the camera.
3. Connect the other end of the power supply into a
120 VAC source.
Powering On
1. Simply switch the Power button on the back of
the CameraMan Camera.