Installing the k2 dyno pa application – Grass Valley K2 Dyno PA Configuration Manual v.1.5 User Manual
Page 44
3. After you install the platform service, reboot the PC or manually start the service.
The service is set to automatic.
4. Proceed to Installing the K2 Dyno PA application.
Related Links
About the K2 Dyno PA application and the Grass Valley platform service
on page 42
About the K2 Dyno PA application and the Grass Valley platform service
on page 42
Installing the K2 Dyno PA application
on page 44
Starting the K2 Dyno PA application
on page 45
Installing the K2 Dyno PA application
The K2 Dyno PA installation software can be obtained from the FTP download site.
Prerequisites:
•
Grass Valley does not recommend the use of a firewall with Dyno PA. If using a
firewall, ensure that the port 49173 is allowed full access on the PC with the Grass
Valley platform service installed and all PCs running Dyno PA.
•
The hardware and software requirements as specified in K2 Dyno PA Prerequisites.
•
If using the Browse feature, follow the procedures described as described in the
section on configuring your K2 Summit system, and then copy the FsNameServers
file from the K2 Summit system to the K2 Dyno PA machine. This file must be in
the C:\SNFS\Config folder on the Dyno PA as well as the K2 Summit system.
Reboot the Dyno PA machine before proceeding.
To install the Dyno PA application, follow these steps:
1. Double-click the
Dyno-PA
file.
2. Follow the installation wizard, and accept the EULA license.
The Dyno PA application is now installed.
3. Once you have installed the Grass Valley platform service and K2 Dyno PA
application, you need to start the Dyno PA application to configure it. Proceed to
Starting the K2 Dyno PA application.
Related Links
About the K2 Dyno PA application and the Grass Valley platform service
on page 42
About the K2 Dyno PA application and the Grass Valley platform service
on page 42
Installing the Grass Valley platform service
on page 43
Starting the K2 Dyno PA application
on page 45
44
K2 Dyno Production Assistant Configuration Manual version 1.5
15October 2010
Configuring the standalone K2 Summit system and K2 Dyno PA