Grass Valley K2 Dyno PA Configuration Manual v.1.5 - Manual (Page 53)

The new repository appears in the Navigator pane.
• File System
a) Enter the name or IP address of the repository host machine.
b) Enter the main UNC share mount point (the network share name).
c) Enter the username and password needed to access this network share.
d) To determine the naming convention for the exported file name, check the box
next to the desired Naming Conventions:
• Use Dyno Keywords in Export Filename: the Dyno Keywords appear as part
of the name in the exported file.
• Use Dyno Marks in Export Filename: Dyno PA puts Dyno marks in the filename
itself, for example: 10:15:25:20-10:22:40:15-S00001.Mov. You can then export
the file with this new filename.
• Restrict Repository Views to Known File Types: Checking this box ensures
that your view is not cluttered with extraneous file types that are not related to
the Dyno PA or K2 system. For example, if your repository points to a USB
disk where Word documents are stored, these documents will not be shown in
the repository if this box is checked.
• If desired, use the Editor Type drop-down list to select Final Cut Pro.
• Specify the volume reference. The volume reference is used to specify, in the
XML file, the filepath where the repository host machine accesses the exported
media. For example, if a volume is mapped on a Mac as the volume PA, then
enter
PA as the volume reference.
CAUTION: If this reference is incorrect, or the same volume is mounted
on another machine with a different name, the repository host machine
will not be able to link the metadata to the media.
• If desired, check the Create a Single File for Each Exported Asset box. If this
box is checked, Dyno PA adds an XML file describing the asset, including
metadata, for each asset exported.
• Click OK . The new repository appears in the Navigator pane.
5. If you are using rules as part of your workflow, proceed to “Configuring a rule”.
Related Links
Managing K2 Dyno PA on page 49
Configuring a rule
Prerequisites:
• At least one destination repository must have been added in the Dyno PA
application.
15October 2010 K2 Dyno Production Assistant Configuration Manual version 1.5 53
Managing K2 Dyno PA