Grass Valley Kalypso Emergency Bypass Option - Manual (Page 16)

16 Kalypso Emergency Bypass Option Instruction Manual
Installation
3. Attach the two closely spaced connectors on the new cable to the same
two boards in the lid (
Figure 7 ). The red marked edge of the ribbon
cable must face down toward the hinge of the lid, to match the pin 1 and
2 side of the connector. These connectors are keyed for this orientation.
Figure 7. Newer Board (671-4945-03) Cable Installation
4. An interconnecting assembly with short and long pins is provided with
the kit. If not already installed, insert the side of the assembly with the
short pins into the remaining open ribbon cable connector, making sure
all connector sockets are filled.
CAUTION Use care when connecting the ribbon cable to the Local Aux Processor Inter-
face board.The connector is not keyed, and equipment damage can occur if
the connector is installed misaligned with the pins.
5. The remaining connector with the long pins protruding attaches to the
J2 connector on the lower left corner of the 671-4945-03 Local Aux
Processor Interface board. Orient the cable with the ribbon emerging
from the left side of the connector. The red marked edge of the ribbon
cable must face up toward the opening of the tub, matching the pin 1
and 2 side of the connector on the board.
6. Route the cable alongside the power supply ( Figure 7 ), using the
supplied adhesive cable restraints.
7. Close the lid and power up the Main panel.
0721_07_70_r2
New Replacement
Cable
Local Aux Processor
Interface Board
(Newer Model)
SATELLIT E PORT S TRANSM IT RECEIV E 8 8 8 8 8 8 8 8 TRANSM IT GP8 GP7
GP6
GP5 GENERA L PURPOS E LEDS
GP4 GP5
GP1
GP0
RECEIV E SATEL LITE P ORTS
FAULT INIT RUN XMT C119 RCV LINK
RTP/C ONTR OL PA NEL L AN ACTIV ITY
COLN C29 3.3V R151 R152 POW ER SU PPLIE S MENU PROC ESSO R RESE T R153 5V 12V SCSI HARD DISK
5 6 7 8 9 0 1 2 34
Final
Cable
Routing