Grass Valley Kalypso User Manual V.15.0 - Manual (Page 309)

Kalypso — User Manual 309
Store Menu
other cases, the animation is designed with a non-looping head and/or tail,
which can be used to transition into and out of the looping section. You will
need to find appropriate loop points to make a looped clip of this type play
seamlessly.
1. Find the repeating section of the clip and set a Loop To point on a frame
just inside its start. The first frame of a repetitive section is not always
the best choice.
1. Go to the frame later in the clip that matches the lop frame you just set.
2. Jog back one field, and set it as the Loop From point.
3. Set a negative loop count so the clip loops constantly and start
playback. Watch the animation carefully at the loop point. If a jump is
visible, adjust the Loop To and/or Loop From points using the soft
knobs while the animation is running until the jump disappears.
4. Stop the clip playback, set the Count to the desired number of repeats,
and touch
Save to save the clip with the modifications.
Machine Control Subpanel Control
Kalypso Still Store stills and clips can be loaded to Still Store outputs and
played using the Machine Control subpanel.
1. Delegate control to the Still Store output by selecting that source on the
Pgm Pst B bus (or whatever bus has been delegated for control with the
Sel Deleg button).
2. Use the Machine Control subpanel controls to Load Sill Store stills, or
to Load, Cue, Play, Jog, and Stop Sill Store clips. You can also mark an
in point from this subpanel. See the Kalypso User Manual for more
information.
You can quickly cache multiple items with the Machine Control subpanel
by loading the items in succession to the same Still Store output.
You can also use the Machine Control subpanel during Still Store clip
recording to cue and play Profile VDR or VTR sources under Kalypso
external device control.
Still Store E-MEM Operations
Still Store E-MEM Enable Buttons
Selected Still Store settings and parameters can be saved in E-MEM effects
for reuse. The Still Store outputs are assigned by default to the E-MEM