England's Stove Works 25PAH - Manual (Page 3)

3
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR
DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.
TABLE OF CONTENTS
Introduction
 Introduction ................................. 4
Specifications
 Heating Specifications .................. 5
 Dimensions ................................... 5
 EPA Compliance ........................... 5
Installation
 Installation Overview ................... 6
 Clearances to Combustibles ......... 7
 Venting Introduction .................... 8
 Venting Guidelines ....................... 8
 Additional Venting Information ... 9
 Vent Termination Clearances .... 10
 Approved Venting Methods
o Through the Wall ........... 11
o Through the Ceiling ........ 12
o Existing Chimney ............ 13
 Mobile Home Installation .......... 14
 Outside Air Hook‐Up .................. 15
 Floor Protection ......................... 16
Daily Operation
 Getting Started ........................... 17
 Lighting a Fire ........................ 17‐18
 Control Board Settings ............... 19
 Error Codes ................................ 20
 Power Failure ............................. 21
 Thermostat Installation .............. 22
 Thermostat Operation ............... 23
 Optional Accessories .................. 23
Maintenance
 Daily
o Important Notes............. 24
o Daily Ash Removal ..... 24‐25
o Cleaning the Burnpot ..... 25
 Monthly
o Important Notes............. 26
o Exhaust Chamber ...... 26‐27
o Venting Pipe ................... 27
 Yearly
o Important Notes............. 28
o Exhaust Blower .............. 29
o Convection Blower ......... 30
o Hopper Fines .................. 30
o Checking Gaskets ........... 30
Troubleshooting Guide
 Troubleshooting .................... 31‐32
Replacing Components
 Auger Motor ............................... 33
 Convection Blower ..................... 34
 Combustion Blower ................... 34
 Vacuum Sensor .......................... 35
 Igniter ......................................... 35
 Gaskets ....................................... 36
 Finish .......................................... 36
 Glass ........................................... 37

Control Board. ............................ 38

Wiring Diagram .......................... 39
Illustrated Parts Detail and Tag
 Exploded Parts Diagram ............. 40
 Parts List ..................................... 41
 Sample Safety Tag ...................... 42
Warranty
 Warranty Details ................... 43‐44
 Warranty Reg. Form .............. 45‐46