England's Stove Works 25PAH - Manual (Page 6)

6
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR
DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.
INSTALLATION
Installation Overview
When choosing a location for your new stove, there are a multitude of
factors that should be taken into account before beginning the installation.
1. Traffic Patterns – To help prevent accidents, the stove should be placed
in a location where it is out of the way of normal travel through the
home.
2. Heat Flow – When deciding on a location for the stove, consider the way
heat moves throughout your home. Install the stove where you need
the heat; basement installations often do not allow sufficient heat to
flow to the upper floors and a top floor installation will not allow any
heat to reach the floors below. Always consider that heat rises and will
take the path of least resistance while it is still hot.
3. Exhaust Location – Outside walls are generally the best place to install a
stove, since they allow easy exhaust and intake air installation (using our
DuraVent AC‐3000 Kit, AC‐33000 if Canada). If there is not a feasible
way to install the stove on an outside wall, there are methods for
venting the stove up through the roof, but they tend to be more costly
because they involve the use of more pellet vent pipe and can often
make outside air installation more difficult.
4. Wall Construction – Locating the stove so that the exhaust system can
pass between studs will simplify the installation and eliminate the need
to reframe any sections of the wall to accommodate the wall thimble.
WARNING
 Do not store or use gasoline or other flammable vapors and liquids in the vicinity of
this or any other appliance.
 Do Not Overfire – If any external part starts to glow, you are overfiring. Reduce feed
rate. Overfiring will void your warranty.
 Comply with all minimum clearances to combustibles as specified. Failure to comply
may result in a house fire.
 Tested and approved for wood pellets only. Burning any other fuel will void your
warranty.