Trouble‐shooting guide – England's Stove Works 25PAH User Manual
Page 31
31
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR
DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.
Trouble‐Shooting Guide
WARNING: To avoid ELECTRICAL SHOCK always disconnect the unit from the power source BEFORE
attempting any repair. If this guide does not correct the problem, call your local dealer or Technical
Support at 1‐800‐245‐6489.
Problem
Cause
Solution
Auger not turning
1. Bad auger motor.
1. Replace auger motor.
2. Foreign matter jamming
auger.
2. Remove pellets and object.
3. Vacuum sensor.
3. Check exhaust blower.
Smoke smell or dust in
house
1. Improper exhaust connection.
1. Check exhaust connections for
leaks, especially the exhaust
blower connect. Seal leaks with
silicone, aluminum tape or a hose
clamp.
Room blower not operating
1. Loose thermal sensor.
1. Tighten connection on sensor.
2. Blower speed set higher than
heat range, causing stove to cool
and blower to cycle.
2. Lower blower speed.
3. Loose connection.
3. Check control board
connection.
Exhaust blower not
operating
1. Loose connection.
1. Check control board
connection.
2. Bad blower.
2. Replace blower.
3. Bad vacuum sensor.
3. Replace vacuum sensor.
Lazy Fire
1. Bad exhaust blower.
1. Inspect and replace blower.
2. Excessive pellet moisture.
2. Keep pellets dry.
3. Excessive ash build‐up.
3. Thoroughly clean unit.
4. Low quality pellets.
4. Use only PFI premium pellets.
Blown Fuse
1. Power surge.
1. Replace fuse; use surge
protector.
2. Exposed wire.
2. Check for exposed or frayed
wire and loose connections.
3. Electrical component shorting. 3. Check motors and blowers for
obstructions or short circuits.
High Pellet Consumption
1. Low quality or non‐uniformly
sized pellets.
1. Use premium pellets or try
another pellet brand.
Squeaking Noise
1. Obstruction in auger tube.
1. Check auger tube for foreign
objects.
2. Blower Noise.
2. Remove, clean, and oil blower.
Pinging or Rattling Noise
1. Foreign material in blower.
1. Check both blowers for
material.