Grass Valley Newton Modular Control System v.2.0 - Manual (Page 56)

56 Newton Instruction Manual
Section 3 — Configuration
Creating A Configuration
There are many ways to configure a Newton Control Panel, from a simple
configuration for one module to extremely complex ones involving many
modules. A configuration example is provided below to learn the concepts
for using the Newton Panel Configurator.
Use the procedure below to learn a sample panel configuration. This
example is based on setting controls for a single module with one channel
and four setups.
1. Open NetConfig and select the Configure Newton Panels button in the
toolbar to open the Newton Panel Configurator.
2. Select the New Config button in the Current Configuration area of the
General Configuration tab to bring up the Enter Names dialog box
(
Figure 40 on page 57 ). Enter a name for the configuration. The
configuration name is used to summarize the functions of the
configuration or can be tied to the panel function itself.
For the example we will name the configuration 10pm_News.