Grass Valley Newton Modular Control System v.2.0 - Manual (Page 95)

Newton Instruction Manual 95
Newton Panel Description
Learn/Recall Button(s)
The Learn/Recall button on the rack mount panel and the Learn and Recall
buttons on the NewtonPC software panel control the operating state of the
12 soft keys on the panel.
Learn Button
The Learn button enables the soft key assignment mode. When the Learn
button green LED is lit on the soft panel or the Learn/Recall button is held
down on the rack mount panel, you may learn the present setup or a router
source or monitored destination selection to one of the soft key buttons on
the panel.
With a soft key selected, holding the Learn/Recall button on the rack mount
panel until the tally light goes out will erase the current soft key assignment
on that button.
Soft key assignments can be made during configuration and downloaded
to a panel or be made directly from the panel and uploaded to the Newton
Panel Configurator to be saved to a file.
Refer to Soft Key Functions and Assignments on page 65 for the soft key
assignment steps using the Newton Panel Configurator.
To upload and save any soft key assignments to the Newton Panel Config-
urator, refer to
Upload Soft Key Assignments to Newton Panel Configurator on
page 104 .
Note Soft key assignments made at the panel are saved on the panel until down-
loaded with another configuration.
This section describes using the software and rack mount control panels to
assign soft keys to the following,:
• Setups ( page 96 )
• Router Sources ( page 98 )
• Router Monitored Destinations ( page 101 )