Grass Valley Newton Modular Control System v.2.0 - Manual (Page 98)

98 Newton Instruction Manual
Section 4 — Operation
Soft Key Router Source Assignment From Control Panel
Use the procedures below to delegate a router source take to a soft key from
the NewtonPC or rack mount control panels.
NewtonPC – Soft Key Router Source Assignments
To make soft key router source assignments from the software panel:
1. Press the Route button to enable the router interface Preset Source mode
( Figure 85 ).
2. Rotate the fourth knob (yellow LED) or use the Plus and Minus buttons,
to bring up the Preset router source (in brackets) you wish to delegate
to a soft key.
Figure 85. Router Source Preset Mode
Use third knob with yellow LED
to select preset source.