Grass Valley PLS200 - Manual (Page 147)

PLS200 Library Installation and Operation 125
19 PICK MECH. FAILURE. The CHM
could not successfully pick from a full
cartridge slot. Open the door and look for anything that might be
obstructing the gripper.
Make sure the library and tape drives are not being used by
any host, then press
on the operator panel. If the
error persists, contact your service provider.
21 GRIP HOME ERROR. A gripper
error occurred.
22 GRIP MOTION TIMEOUT. A
gripper motion took longer than the
maximum time allocated for it. When
motion functions do not complete in
the allocated time, the current to the
servo motors is shut off.
25 PICK STALL. The CHM stalled
while trying to pick a cartridge from
the tape drive.
26 CANNOT OPEN GRIPPER. The
gripper could not open.
30 S AXIS DOES NOT MOVE. The
CHM could not move along the short
axis. Open the door and look for anything that might be
obstructing the CHM along its short axis.
Make sure the library and tape drives are not being used by
any host, then press
on the operator panel. If the
error persists, contact your service provider.
31 S AXIS FAILED HOME. The CHM
could not return to the home position
along the short axis.
36 S LM629 RESET FAIL. The library
could not reset the servo chip for the
short axis. Make sure the library and tape drives are not being used by
any host, then press
on the operator panel. If the
error persists, contact your service provider.
38 CANNOT LOAD DRIVE. The CHM
could not load the cartridge into the
tape drive. (It could not move in far
enough on the short axis.) • Open the door and look for anything that might be
obstructing the CHM along its short axis.
• Make sure that a cartridge is not already loaded in the
tape drive.
• Make sure that the flap on the cartridge is closed.
• Make sure the library and tape drives are not being used
by any host, then press
on the operator panel.
If the error persists, contact your service provider.
Error Description Corrective Action
Reset
Reset
Reset
Reset