Grass Valley PLS200 - Manual (Page 27)

Installing the SCSI Adapter Into the VDR
PLS200 Library Installation and Operation 5
3. Remove the two circuit board hold-downs as shown in Figure 1-2. Both
hold-downs are held in place by T-10 TORX head screws, and must be
removed in order to install the SCSI adapter board.
➤ Important Be sure to remove the jumper as described in the following step.
If the jumper is left in place, the VDR will display an error when initializing
the SCSI adapter board.
4. Unpack the SCSI adapter board and remove the jumper from W1 on the
board. Refer to the manual packed with the board to locate the jumper.
Figure 1-2 Removing the circuit board hold-downs