Grass Valley PLS200 User Manual
Page 84
Chapter 5 Maintaining the Library
62
PLS200 Library Installation and Operation
Install the Tape Drive
➤
Important
Do not insert your fingers in the tape drive door.
1. As shown in Figure 5-1, insert the tape drive into the slot with the lever to
the right. Make sure the lever is closed. The tape drive should slide easily
toward the back.
2. When the drive is almost completely inside the slot, you will feel some
resistance. This is caused by the connection between the library's controller
card and the tape drive. To seat the connection, push firmly against the drive
until you can push no further.
3. Using a flat-blade screwdriver, tighten the captive screw on each end of the
drive carrier faceplate (two screws).
Resume Library Operations
1. Connect the power cord to the back of the library.
2. Close and lock the library's door.
3. Turn the library power switch to on.
NOTE: When you replace a tape drive, the new tape drive automatically assumes the
SCSI ID of the old tape drive. See page 34 if you want to change the SCSI ID.