Grass Valley Profile XP Service Manual - Manual (Page 109)

Replacing parts in a system with the redundancy option
23 July 2004 Profile XP Service Manual 109
Interpreting the DupliDisk II control panel LEDs
The following describes how to interpret the control panel LEDs. The Primary and
Mirror LEDs display the status of the disk hardware on the Primary and Mirror
channels. The Master and Slave LEDs display the RAID status on the Master and
Slave disk channels.
NOTE: In the Profile XP, the Slave channel LED is always lit because no slave
drives are installed.
Operation of the DupliDisk II control panel buzzer
The following describes how to interpret the operation of the control panel buzzer.
Primary LED Mirror LED Status
ORANGE ORANGE Channel activity (Read/Write)
ORANGE
(flashing) ORANGE
(Flashing) Scanning the channel for drives
GREEN GREEN Drives installed on the channel
RED
(Flashing) GREEN Error on Primary Channel, the channel is marked as bad
GREEN RED
(Flashing) Error on Mirror Channel, the channel is marked as bad
RED GREEN Drive not installed on Primary channel
GREEN RED Drive not installed on Mirror channel
Master LED Status
RED Drives detected are NOT in Mirror Mode
GREEN
(Flashing) Drives detected are in Mirror Mode, but may NOT be Identical
GREEN Drives are in Mirror Mode and are Identical
RED
(Flashing) Copy or compare operation is in progress
Orange
(Flashing) Scanning for drives
Buzzer operation
a
a. Buzzer Off switch can be depressed to stop the beeping.
Status
Short beep during power up Indicates successful DupliDisk II self test
Second beep DupliDisk II is running in single mode
Continuous or intermittent beep Drive failure