Instruments, features and controls, Tilt sensor, Storage compartments (cross country tour) – Polaris 2016 Victory Cross Country User Manual
Page 34: Fairing vents and deflectors (cross country tour), Passenger floorboard supports (cross country tour)
32
Instruments, Features and Controls
Tilt Sensor
A tilt sensor stops the engine if the motorcycle tips beyond 45 degrees to one side. The check
engine light or message will also activate. To restart the engine, cycle the ignition switch to
the OFF position, wait 20 seconds, then restart the engine.
Storage Compartments (CROSS COUNTRY TOUR)
A storage compartment is located at the top of each lower fairing. The maximum weight
capacity for each compartment is five pounds (2.3 kg). Optional door locks are available for
these compartments.
The left compartment contains the iPod cord and a second 12-volt accessory outlet. To open
a compartment door, pull the door handle and allow the door to pivot downward. Do not
force a door to open beyond the door pivot stop.
Fairing Vents and Deflectors (CROSS COUNTRY TOUR)
An air vent and a deflector are located in each lower fairing. Use the vent handles to open
and close the vents. Do not force a vent to open beyond the vent pivot stop. Move a deflector
inward or outward to adjust air flow.
WARNING! Failure to inspect deflector clearance after removing and reinstalling a fairing could result
in steering interference, which could result in serious injury or death.
After removing and reinstalling a fairing, always check for adequate steering clearance by
moving the handlebars fully to the left and fully to the right, first with the deflectors open
and again with the deflectors closed. Make any adjustments necessary to ensure steering
clearance.
Passenger Floorboard Supports (CROSS COUNTRY TOUR)
The passenger floorboard height and angle can be adjusted. To
adjust the angle, loosen both attachment screws. Rotate the
floorboard to the desired position using the indicator mark on
the rear-facing support as a guide, then tighten the screws.
Torque: 18 ft-lbs (24.4 Nm)
To adjust the height, remove both attachment screws. Move the
floorboard assembly to the next hole position, then reinstall the
fasteners, adjust the angle and tighten the fasteners to the rec-
ommended torque.
Vent
Handles
Vent Pivot Stop
12-Volt Outlet,
iPod Cord or
Auxiliary Cord
(if equipped)
Door
Handle
Deflector
Attachment
Screws