Operation, Reverse operation (if equipped) – Polaris 2016 Victory Cross Country User Manual
Page 52
50
Operation
Reverse Operation (if equipped)
NOTICE: Do not attempt to engage or disengage the reverse system when the motorcycle is moving.
Before Operating in Reverse:
• always sit on the motorcycle with legs astride and both feet on the ground.
• always check for obstacles or people behind the motorcycle.
• always retract the sidestand fully.
• always make sure the motorcycle is completely stopped.
NEVER Operate in Reverse:
• when not properly seated.
• when in an area where obstacles or bystanders are present.
• with a passenger on board. A passenger can obstruct your view and maneuverability.
• when on loose or slippery surfaces. Loss of foot traction could cause a tip-over.
• while the motorcycle is moving forward.
• when on a grade or uneven surfaces.
Reverse Operation Procedure
1. Always check for obstacles or people behind the motorcycle. Be aware that the front
wheel may travel outward and require a larger operating area.
2. Make sure the motorcycle is stationary.
3. Dismount any passenger.
4. Sit on the operator’s seat with legs astride and both feet on the ground.
5. Retract the sidestand (if down).
6. Place the transmission in neutral.
7. With the engine idling, lift the reverse lever and verify that the reverse indicator (R)
displays in the multi-function display.
NOTICE: NEVER shift the transmission into gear with the reverse engaged. Doing so WILL result in
damage to the reverse system.
8. Recheck the area behind and around the motorcycle to ensure a clear operating area.
9. While balancing the motorcycle with your legs and feet, press and hold the starter switch
to begin moving in reverse. Release the switch to stop moving.
NOTICE: NEVER shift the transmission into gear with the reverse engaged. Doing so WILL result in
damage to the reverse system.
10. If parking the motorcycle, wait until it’s completely stopped, then move the reverse lever
down to the disengaged position. Verify that the neutral indicator (N) displays before
stopping the engine.