Cleaning and storage, Gloss clear coat finish care – Polaris 2016 Victory Cross Country User Manual
Page 95
93
Cleaning and Storage
Gloss Clear Coat Finish Care
The Axalta Sports and Equipment Finish System was used to provide the original gloss
finish on your motorcycle. This finish system provides superior protection against the
elements. To maximize the benefits of this system, use the following guide to care for the
gloss finish on your motorcycle.
• During the first 30 days, when the finish is still fresh, clean the motorcycle with a water
rinse only.
• Do not wax the motorcycle for the first 60 days. Doing so can cause loss of the gloss. After
60 days, use only waxes designed for new clear coat finishes.
• Do not use pressurized water to wash the motorcycle. When paint is still fresh, pressurized
water could damage the finish. If using a pressure washer is unavoidable, keep the spray
nozzle at least 24 inches (60 cm) away from the surface of the motorcycle.
• Wash your motorcycle often, especially when exposed to salty, dusty, acidic or alkaline
environments.
• Use warm or cool water and a soft cloth for cleaning.
• Use soaps that are non-abrasive and have a neutral pH (non acidic/non alkaline
detergents).
• Do not use solvent-based solutions.
• Do not use a dry cloth to remove dust.
• Do not use a stiff bristle brush, which can scratch the surface.
• Do not wash with extremely hot water.
• Do not wash the motorcycle while the surface is hot and avoid washing the motorcycle in
the hot sun. Minerals in the water may be difficult to remove once dried on the surface of
the motorcycle.
• Do not allow spilled gasoline, motor oil or brake fluid to stand on the paint. Remove these
substances immediately by rinsing with water. Use a soft cloth to absorb any remaining
residue and dab dry.
• To remove bug remnants or road tar, use only products that are specifically designed for
this purpose. Follow the product manufacturer’s recommendations to prevent potential
damage to the finish. Follow with a wash using the methods described in this section.
• Always brush away any ice or snow, do not scrape off.
• Chips or scratches should be repaired promptly to prevent corrosion.