Polaris 2016 Victory Cross Country - Manual (Page 51)

49
Operation
Stopping the Engine
Before stopping the engine, bring the motorcycle to a complete stop. Shift to neutral or
disengage the clutch.
WARNING! Stopping the engine with the transmission in gear while the motorcycle is moving could
cause loss of rear wheel traction or engine and transmission damage, which could cause loss of control
and serious injury or death. Always stop the engine after the motorcycle is fully stopped and the
transmission is in neutral. If the engine stops unexpectedly while the motorcycle is moving, guide the
motorcycle to a safe location off the road and away from traffic.
1. When fully stopped, shift into neutral.
2. Move the engine stop/run switch to the STOP position.
3. Move the ignition switch to the OFF position. Remove the ignition key.
Tip: A momentary clicking sound from the IAC valve is normal when the key is first turned to the OFF
position.
Parking
Choose a firm level surface to park the motorcycle.
1. When fully stopped, shift into neutral.
2. Stop the engine.
3. Fully extend the sidestand.
4. Turn the handlebars to the left and lean the motorcycle to the left until the sidestand
firmly supports the motorcycle.
5. Remove the ignition key.
Parking on a Slope
If parking on a slope is unavoidable, position the front of the motorcycle toward the top of
the slope. Place the transmission in gear and position the motorcycle so that it is stable when
it rests on the sidestand.
Parking on a Soft Surface
If parking on a soft surface is unavoidable, place a sidestand footrest under the foot of the
sidestand to provide a firm surface. The sidestand footrest must be strong enough and large
enough to support the motorcycle's weight without sinking into the parking surface.
Asphalt becomes soft in hot weather. A sidestand can sink into soft asphalt and the
motorcycle may fall. When parking on asphalt in hot weather, use a sidestand footrest.
CAUTION! Hot engine and exhaust components can cause burns to skin and can ignite a fire if
exposed to flammable materials. Always park the motorcycle clear of flammable materials and where
people are not likely to contact hot components.