Logitek Electronic Systems ROC - Manual (Page 12)

Logitek ROC Reference Manual
Page 12
3 Physical Installation
The ROC surface is designed to be mounted on a desk in a semi-permanent studio installation. The
Meter Bridge
, if optioned, can be screwed to the back of the ROC.
Power Supply Unit
The Power Supply Unit is an external supply.
Power inlet is via a single IEC connector on the rear of the Power Supply Unit. A power cable is
supplied only for US installations. International customers may contact their reseller for the supply
of power cables if required.
As the power supplies are of switch-mode type, there is no voltage selection required.
ROC Frames
A number of ROC frame sizes are available, depending on the total number of faders. Each module
takes up either one or two “slots” in the frame. The Monitor module occupies half the slot space of
a Fader module.
The frame will be shipped with the modules connected and fitted as ordered. These modules are
not intended to be moved, however Fader modules are interchangeable. The internal COM port
connections determine the device addressing for each modules.
ROC-F9 9 Slot Frame
 Houses 1x ROC-FADER & 1x ROC-MON
 12.9” W x 14.3” D x 2.5” H (328mm x 368mm x 63mm)
ROC-F12 12 Slot Frame
 Houses 2x ROC-FADER & 1x ROC-MON
 16.8” W x 14.3” D x 2.5” H (427mm x 368mm x 63mm)