Meter bridges (roc-smeter, roc-lmeter) – Logitek Electronic Systems ROC User Manual
Page 13
Logitek ROC Reference Manual
Page 13
ROC-F18 18 Slot Frame
Houses 3x ROC-FADER & 1x ROC-MON
25.6” W x 14.3” D x 2.5” H (625mm x 368mm x 63mm)
ROC-24 Frame
Houses 4x ROC-FADER & 1x ROC-MON
33.95” W x 15.4” D x 2.6” H (862mm x 391mm x 66mm)
Meter Bridges (ROC-SMeter, ROC-LMeter)
Hardware LED Meter Bridges are available as an option. The Meter includes two high-resolution
meters – one for Program bus and one switched (follows Monitor selection).
TIP:
If the ROC is powered on without being connected to the JetStream, all meter LEDs
will illuminate. This is normal operation; the LEDs will turn off after being
connected to the JetStream and the console begins to receive meter data.
Mounting
The Meter option is supplied separately and attaches to the back of the ROC frame with
screws (included).
The RJ-11 cable from the Meter plugs into the ROC tray card at the far right into the jack
labeled “Meter.”
The Meter is hinged. Gently tighten the black center screw on the rear of the hinge to lock
the meter into place at the desired angle.
Illustration 1: ROC-SMeter