Logitek Electronic Systems ROC - Manual (Page 25)

Logitek ROC Reference Manual
Page 25
ROC Modules
ROC-FADER (Fader Module) – International (non-UK) Layout
CNG – Change button. Press to route a new
source to this fader. Use the select knob on the
monitor module to scroll through the sources on
the OLED display below the fader. Press Take on
the monitor module to select the source; Cancel
to clear change mode. Change mode will also
automatically turn off after 5 seconds of
inactivity.
P button – Program bus select. Press to send
this channel to the program mixing bus. The
lamp on the button will illuminate to show
whether the bus is assigned or not. The lamp
will glow at half brightness when the channel is
off and full brightness when the channel is on.
A1 button – Aux 1 bus select. Press to send this
channel to the Aux 1 mixing bus. The lamp on
the button will illuminate to show whether the
bus is assigned or not. The lamp will glow at
half brightness when the channel is off and full
brightness when the channel is on.
A2 button – Aux 2 bus select. Press to send this
channel to the Aux 2 mixing bus. The lamp on
the button will illuminate to show whether the
bus is assigned or not. The lamp will glow at
half brightness when the channel is off and full
brightness when the channel is on.
A3 button – Aux 3 bus select. Press to send this
channel to the Aux 3 mixing bus. The lamp on
the button will illuminate to show whether the
bus is assigned or not. The lamp will glow at
half brightness when the channel is off and full
brightness when the channel is on.
TB/Soft button – This button turns on bus 14 for the fader.
By default, if a source with a mix minus bus is routed
here, the talkback mic will be sent to the mix minus. If no
mix minus bus is associated with the source, a trigger may
be written in Command Builder to perform another
function when the button is pressed.
Cue button – Press to listen to the
source through the internal cue
speaker regardless of fader position
or whether the channel is on or off.
Fader – Adjusts level for the selected mixing busses.
OLED Display – Text shows channel assignment. A pre-fader
meter appears below the text.
Turns fader on
Turns fader off