Logitek Electronic Systems ROC - Manual (Page 26)

Logitek ROC Reference Manual
Page 26
ROC Modules
ROC-FADER (Fader Module) – UK Layout
P button – Program (Desk) bus select. Press to
send this channel to the program mixing bus.
The lamp on the button will illuminate to show
whether the bus is assigned or not. The lamp
will glow at half brightness when the channel is
off and full brightness when the channel is on.
A1 button – Aux 1 bus select. Press to send this
channel to the Aux 1 mixing bus. The lamp on
the button will illuminate to show whether the
bus is assigned or not. The lamp will glow at
half brightness when the channel is off and full
brightness when the channel is on.
A2 button – Aux 2 bus select. Press to send this
channel to the Aux 2 mixing bus. The lamp on
the button will illuminate to show whether the
bus is assigned or not. The lamp will glow at
half brightness when the channel is off and full
brightness when the channel is on.
A3 button – Aux 3 bus select. Press to send this
channel to the Aux 3 mixing bus. The lamp on
the button will illuminate to show whether the
bus is assigned or not. The lamp will glow at
half brightness when the channel is off and full
brightness when the channel is on.
TB/Soft button – This button turns on bus 14 for the fader.
By default, if a source with a mix minus bus is routed
here, the talkback mic will be sent to the mix minus. If no
mix minus bus is associated with the source, a trigger may
be written in Command Builder to perform another
function when the button is pressed.
CNG – Change button. Press to route a new source
to this fader. Use the select knob on the monitor
module to scroll through the sources on the OLED
display below the fader. Press Take on the monitor
module to select the source; Cancel to clear change
mode. Change mode will also automatically turn off
after 5 seconds of inactivity.
Fader – Adjusts level for the selected mixing busses.
Turns channel on and off when raised from infinity.
OLED Display – Text shows channel assignment. A pre-fader
meter appears below the text.
Machine Start
PFL (Pre Fader Listen)