Casio YC-430 - Manual (Page 27)

E-27
Setting Up the Multi PJ Camera System
z Make sure that PJ Camera Software is installed on your computer before trying to perform the
following procedure.
After you install PJ Camera Software on the computer, connect the PJ Camera Stand, computer,
and projector as shown below.
z Normally, it is a good idea to have all of the components turned off when connecting or
disconnecting them.
z You can leave components turned on when connecting or disconnecting a USB cable. However,
disconnecting a USB cable while data transfer is in progress can cause corruption of the data
or malfunction of the equipment.
Connecting Multi PJ Camera System Components
Projector
RGB Cable
A-B USB Cable
Computer