EverFocus EDR-1640 - Manual (Page 54)

3.12 SYSTEM MENU
Define the following settings in the SYSTEM menu:
(1) SYSTEM VERSION: Display of the installed firmware version.
(2) SYSTEM VIDEO FORMAT: Display of the detected video system PAL or NTSC. The EDR
automatically detects the video system upon system startup.
ATTENTION: Auto detection checks video input 1 upon system startup.
Therefore, it is compulsory to start the DVR with video signal connected to
channel 1. Otherwise, default setting NTSC is loaded!
(3) SAVE/LOAD CONFIGURATION:
Selecting YES opens a sub menu showing the following items (use the JOG
for selection):
CANCEL: Return to system menu
DEFAULT: Load default setting after security request YES/NO
ATTENTION: The network settings remain stored despite loading default setting!
SAVE: Save the current configuration to CF card / USB stick.
LOAD: Load a configuration from CF card / USB stick.
(4) UPDATE SYSTEM SOFTWARE: DVR update with latest firmware version through USB-stick
or CF card. At first, place the CF card or the USB stick into the respective
interface.
YES: After confirmation with SELECT, the firmware update is run. Update is
carried out in 3 phases (display at bottom screen margin) and can take up to
5 minutes.
ATTENTION: 1. Before starting the update, stop the recording process.
2. Do not switch the DVR off while update is run.
3. Do not remove CF card or USB stick while update is run.
NO: Cancel, return to SYSTEM menu
53
SYSTEM SETUP MENU
SYSTEM VERSION V1.22
SYSTEM VIDEO FORMAT PAL
LOAD/SAVE CONFIGURATION NO
UPDATE SYSTEM SOFTWARE NO
LANGUAGE ENGLISH
QUICK PLAY
ON 10 MINUTES AGO
SYSTEM PASSWORD ENABLE NO
PASSWORD RIGHTS
LEVEL-3 ************* ADMINISTRATOR
LEVEL-2 ************* OPERATOR
LEVEL-1 ************* GENERAL