Extron electronic Multi-Graphic Processor MGP 464 DI - Manual (Page 28)

Operation, cont’d
MGP 464 • Operation 3-4
PRELIMINAR
Y
6 feet
(1.8 m)
Part #70-335-01
9DBF-2.5mm TRS cable_031504.eps
5
1
9
6
Sleeve (Gnd)
Ring
Tip
9-pin D Connection TRS Plug
Pin 2 Computer's RX line Tip
Pin 3 Computer's TX line Ring
Pin 5 Computer's signal ground Sleeve
Optional 2.5 mm connector cable for the front panel Config port
See chapter 4, “Software Configuration and Control,” for details about using
the configuration software and the SIS commands to configure the MGP.
Power-up and Default Cycle
When you first plug the MGP 464 into a power source, the LCD screen displays
a series of initial messages, followed by the default cycle of screens showing the
current input type for each window and the output resolution and refresh rate.
These messages continue to cycle on the LCD screen when the menu system is not
in use. The following flow diagram shows the order in which these screens appear.
Default Cycle
Multi-Graphic
Processor
2 sec.
Window 1 DVI
000.0 kHz 000.0 Hz
Window 2 RGB
000.0 kHz 000.0 Hz 2 sec.
Output Rate
1280 x 1024 @ 60 Hz
2 sec.
Extron
MGP 464 HD-SDI Vx.xx
Power
on
Extron
MGP 464 DI Vx.xx
2 sec.
Window 3 RGB
000.0 kHz 000.0 Hz
2 sec.
Window 4 RGB
Freeze Enabled 2 sec.
2 sec.
Extron
MGP 464 Vx.xx
Default cycle example
N From any menu or submenu, the MGP 464 saves all adjustment settings and
times out to the default screens after 20 seconds of inactivity.