Extron electronic Multi-Graphic Processor MGP 464 DI - Manual (Page 30)

Operation, cont’d
MGP 464 • Operation 3-6
PRELIMINAR
Y
Menus, Configuration, and Adjustments
The MGP 464’s menus enable you to configure the processor. The menu navigation
buttons (Menu and Next) are located to the lower left of the LCD screen. Press
these buttons to cycle through the available menu and submenu options.
Menu system overview
The MGP 464’s menu system consists of a main menu with nine options (menus).
Each of these nine menus has a set of submenus, which enable you to make desired
adjustments. (See the diagram on page 3-7.)
Using the menus
To use the menus to configure the system,
N If you do not press a button or turn a knob for 20 seconds, the MGP 464 saves
any settings you have made and the LCD screen reverts to the default cycle.
1 . Main menu — To access the Main menu, press the Menu (left) button, located
below and to the left of the LCD screen. The first Main menu option (Auto
Image) is displayed on the screen.
2 . Main menu options (menus) — By repeatedly pressing the Menu button, you
cycle through the Main menu options. Press the Menu button repeatedly until
the desired menu is displayed.
3 . Submenu options — When the Main menu item that you want to configure is
displayed on the LCD screen, press the Next button (at the right of the Menu
button) to cycle through the displayed menu’s submenu options.
4 . Adjustments — The third level of menu selections consists of sub-menu
options that are selected by turning the horizontal ( [ ) and vertical ({)
Adjust knobs. When you have displayed the submenu option that you want
to configure, turn the knobs clockwise or counterclockwise to display the
parameters available for the selected option.
5 . Implementation — To save and implement the adjustments you have
selected, do one of the following:
• Press Next to display another submenu option to adjust.
• Press Menu repeatedly until the Exit menu screen appears, then press
Next.
• Do nothing more, and wait until the LCD screen returns to the default
cycle.
Your adjustments remain in effect until you change them or reset the unit to factory
defaults (see “Resetting,” later in this chapter).