Edirol PC-50 - Manual (Page 20)

20
Getting Connected and Installing Drivers (Windows)
fig.05-5_40
9
In the dialog box that appears,
input the following into the
“Open” field, and click [OK] .
(drive name):\Driver\XP2k\SETUPINF.EXE
* In the explanatory example shown here, the drive name is given as “D:.” The drive
name “D:” may be different for your system. Specify the drive name of your CD-
ROM drive.
The SetupInf dialog box will appear.
You are now ready to install the driver.
10
Set the PC-50’s ADVANCED DRIVER Switch to the ON position.
* Installation cannot proceed as described below if the switch is turned OFF.
11
Use the USB cable to connect the PC-50 to your computer.
1. Set the PC-50’s power switch to the OFF position.
2. Use the USB cable to connect the PC-50 to your computer.
12
Set the PC-50’s power switch to the USB position.
Near the task bar, your computer will indicate “Found New Hardware.”
Please wait.
13
The Insert Disk dialog box will appear.
Click [OK] .
To check the drive name
In the Windows desktop,
double-click the My
Computer
icon. In the
window that appears,
check the drive name of
the CD-ROM drive into
which you inserted the
CD-ROM in step7.
The drive name is the (D:)
or (E:) displayed by the
CD-ROM drive
.
Once the connections have
been completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong
order, you risk causing
malfunction and/or
damage to speakers and
other devices.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.
If the “File signature verification” (Step 4) (p. 19) setting was not set to
“Ignore,”
a “Digital Signature Not Found” dialog box will appear.
If “File signature verification” is set to “Warn”
1. Click [Yes].
2. Continue the installation.
If “File signature verification” is set to “Block”
1. Click [OK].
2. When the “Found New Hardware Wizard” appears, click [Finish].
3. Return to step 1 (p. 19) and re-install the driver from the beginning
of the procedure.
If the Insert Disk dialog
box does not appear,
proceed to the next step.
PC-50_e.book 20 ページ ２００５年１１月１０日 木曜日 午前１０時３３分