Edirol PC-50 - Manual (Page 35)

35
Getting Connected and Installing Drivers (Macintosh)
7
From the File menu, choose Open .
8
Select PC-50 from the FreeMIDI Setting folder you copied in step 3 , and
click [Open] .
9
Verify that MIDI transmission and reception occur correctly.
From the MIDI menu, choose Check Connections .
fig.FreeMIDI
10
Try playing the keyboard of the PC-
50. If
in the diagram at right
changes to a shape, the settings
have been made correctly.
If a MIDI sound module is connected
to the PC-50’s MIDI OUT connector,
click the
PC-50 MIDI OUT icon shown
in the diagram at the right. If you hear
sound, the settings have been made
correctly.
11
Once again choose the MIDI menu command Check Connections to end
the test.
12
From the File menu, choose Quit to exit FreeMIDI Setup .
If you are unable to select
Open
, make settings as
follows.
1.
From the File menu,
choose FreeMIDI
Preference
.
2. Uncheck “Use OMS
when available.”
3. Close FreeMIDI.
Return to step 4 and
continue the procedure.
For details on the PC-50’s
output devices, refer to
“Input / output devices”
(p. 36).
This completes installation of the driver.
Next, make MIDI device settings in your sequencer or other software.
For details on how to make these settings, refer to the owner’s manual for your software.
For details on the PC-50’s output devices, refer to “Input / output devices” (p. 36).
PC-50_e.book 35 ページ ２００５年１１月１０日 木曜日 午前１０時３３分