Edirol PC-50 - Manual (Page 36)

36
Input / output devices
In order to obtain the best performance from your software, you must make the appropriate input/
output device settings.
For details on these settings, refer to the owner’s manual for your software.
* If you are unable to select the PC-50 in the device settings for your software, it is possible that the driver
was not installed correctly. Please reinstall the driver.
fig.flow-USB
MIDI OUT DEVICE
PC-50 MIDI OUT
If you specify PC-50 MIDI OUT as the output port for your sequencer software, messages
will be transmitted from the MIDI OUT connector of the PC-50 itself.
* Turn MIDI I/F MODE ON as described in “MIDI I/F MODE” (p. 65) .
MIDI IN DEVICE
PC-50
This port receives messages from the keyboard, Pitch Bend/Modulation Lever, and VALUE
encoder.
The port assignment determines how the keyboard, Pitch Bend/Modulation Lever, and
VALUE encoder are mapped to PC-50.
MIDI OUT
PC-50 PC USB
PC-50 MIDI OUT
PC-50 PC-50 KEYBOARD
MIDI I/F MODE ON
MIDI OUT DEVICE
MIDI IN DEVICE
MIDI OUT
PC-50 PC USB
PC-50 MIDI OUT
PC-50 PC-50 KEYBOARD
MIDI I/F MODE OFF
MIDI OUT DEVICE
MIDI IN DEVICE
PC-50_e.book 36 ページ ２００５年１１月１０日 木曜日 午前１０時３３分